Robertson QLD 4109 ยท Southside
EV Charger Installation Robertson
Connex Electrical, a licensed electrical contractor (#92217) based in Mango Hill, installs EV chargers in Robertson. Standard home installs are from $990 installed (inc GST), take about 2 to 4 hours and come with a fixed written quote. Robertson is a small, settled suburb of brick homes between Sunnybank and Griffith University, where many original houses now sit beside larger rebuilds.
- Licensed electrical contractor #92217
- $20M public liability
- Local team based in Mango Hill
- Fixed written quotes
- Read our Google reviews
Charging setups that suit Robertson
The original Robertson homes are mostly lowset brick houses from the 1960s and 1970s, typically with a garage or carport attached to one side. A growing number have been replaced by large new houses, sometimes built right to the boundaries with an internal double garage. These two kinds of home lead to two kinds of quote.
On an original brick home, the questions are the board and the route. Many older boards have had a safety switch added but have little room left. The cable often goes through the roof space, which is tight on low-pitched roofs, so we look at whether an external conduit run is neater.
On a rebuild, the board is modern and the garage is usually right beside it. The main thing to settle is the charger itself: whether you want solar matching, an app, or just a plain unit that charges overnight.
How much does EV charger installation cost in Robertson?
In Robertson, most home EV charger installs come in at Connex Electrical's standard price of $990 inc GST, with the charger extra unless you already own one. What can add to it is distance from the switchboard to your parking spot, the condition of the board, and whether you want three-phase. All of that is priced upfront in writing.
| Situation | Price |
|---|---|
| Garage or carport close to a modern switchboard | From $990 installed (inc GST) |
| Charger on the far side of the house, or a detached garage | Standard price plus the extra cable, quoted from photos |
| Older board with fuses or no safety switches | Standard price plus a switchboard upgrade, quoted separately |
| Three-phase home with an 11kW or 22kW charger | Quoted per job |
Included as standard: a new charger circuit and protection at your switchboard, cabling within the standard allowance, mounting, app setup, testing and a compliance certificate. The charger itself is extra unless you already own one.
Affordable EV charger installation in Robertson
- Charge overnight on an off-peak tariff, or from surplus solar, to keep running costs low.
- Choose a 7kW single-phase charger. It suits almost every household and avoids three-phase costs.
- Mount the charger on the garage wall closest to the meter box. A shorter run is the easiest saving.
- Send clear photos of the switchboard and charger spot, so we can quote without a site visit.
Robertson is about 37 km from Mango Hill and roughly 40 minutes away via the Gateway Motorway. We give you an arrival window the day before and keep you updated if traffic changes it.
Every Robertson job gets a fixed written price before any work starts, so the quote is what you pay. For a line-by-line breakdown, see the EV charger installation cost guide for Brisbane, or call 0474 207 609.
Robertson neighbourhood notes
Robertson's position near Kessels Road and Mains Road puts the motorway, Sunnybank's shops and Garden City within a short drive, so many residents make lots of short trips rather than long commutes. That pattern suits home charging well. An EV that only covers local errands might need a charge just twice a week. Most cars only need to start charging after midnight to be full again by breakfast.
Being close to Griffith University's Nathan campus, some homes are rented to students or academics. Tenants need written landlord approval before a charger is installed. If you own and rent the property out, a wallbox can be a useful feature for future tenants. Our EV charger brands page compares the units we install most often.
How the installation works
- Step 1
Request a quote
Use the form or call us. Photos of the meter box and garage speed things up.
- Step 2
We confirm the details
Supply capacity, cable route and any Energex requirements are checked before we book.
- Step 3
We install
Circuit, protection and charger, usually done in 2 to 4 hours.
- Step 4
You start charging
We commission the charger with your car and leave you with your Certificate of Testing and Compliance.
Robertson EV charging FAQs
My Robertson house has a very low roof. Can the cable still go through it?
Sometimes, but not always. Low-pitched roofs on older brick homes can make the roof space hard to work in. In that case we run the cable along the outside wall in UV-rated conduit, which is tidy and easy to service. We decide on the route at the site visit or from photos and include it in the fixed price.
How much does EV charger installation cost in Robertson?
A standard single-phase install in Robertson is from $990 inc GST with Connex Electrical, plus the charger unless you already have one. Long cable runs, switchboard upgrades and three-phase chargers cost extra and are quoted in writing first. Most installs take 2 to 4 hours.
How can I keep EV charger installation affordable in Robertson?
Put the charger close to the switchboard, choose a 7kW single-phase unit and send photos so we can quote without a visit. If you already have a charger, you only pay for installation, at the standard $990 inc GST. Every quote is fixed, so there are no surprises on the day.
Which EV charger should I buy?
Choose on three things: whether you want solar-matched charging, whether you need an app and scheduling, and your budget. A Tesla Wall Connector suits Tesla owners and works with other EVs too. A Zappi or Wattpilot suits solar homes. Simpler units suit plain overnight charging. Tell us your car and setup and we will recommend two or three options.
Will my switchboard cope with an EV charger?
Usually yes, but older boards are the most common reason a quote goes up. A charger needs its own circuit with RCD protection and enough spare capacity in your supply. Boards with ceramic fuses, no room for new devices or no safety switches generally need an upgrade first. We check the board on the site visit or from photos and tell you before you commit.
I am renting. Can I still get a charger installed?
Yes, with your landlord or agent agreeing in writing first. A wallbox is a fixed electrical installation, so the owner must approve it. Many landlords say yes because it adds value to the property. We can give you a quote and a short scope of works to send to your property manager.
Also installing near Robertson
See every suburb in Southside, or read about home EV charger installation, commercial and body corporate charging and the cost of installation in Brisbane.
Book your Robertson EV charger install
Send a few details and photos of your switchboard and charger spot. Most homes can be quoted without a visit.
Call 0474 207 609Connex Electrical, QLD Electrical Contractor Licence #92217. $20M public liability. Based in Mango Hill, servicing Brisbane and Moreton Bay.